Ustawianie zaplonu Igeneracja
: 2003-04-26 08:07
Kto z was wie jaki kąt wyprzedzenia powinien byc w I generacji 2,2 L bez Turbo??
W programie znajdziesz jeszcze ilustracje...Ignition Timing
1. Warm up the engine to the normal operating temperature.
2. Turn all electrical loads off.
3. Connect a tachometer to the engine using the instructions included with the tachometer.
4. Connect a timing light to the engine.
5. Connect a jumper wire between the black one-pin STI test connector and ground.
6. Check the idle speed. If necessary, adjust it to the specified speed.
Idle Speed: 750 ± 25 rpm.
7. Check to be sure the yellow timing mark on the crankshaft pulley and the mark on the timing belt cover are aligned.
Ignition Timing: 6 ± 1° with the vacuum hoses disconnected and plugged.
8. If the marks are not aligned, loosen the distributor lock bolt and turn the distributor housing to make the adjustment.
9. Disconnect jumper wire from the test connector.
10. Connect the vacuum hoses.
11. Tighten the distributor lock bolt to 19-25 N-m (14-19 lb-ft).
93_94C11.ISO to jest 'Ford TSP 1993-1994' (instrukcja serwisowa i schematy)t0mpre pisze:to sa te iso co jeden z kolewgow niedawno udostepnil?